Beef tallow is one of the best fats you can fry in. It holds up at frying temperatures, its smoke point is about 400°F, and it gives fries and fried chicken a crisp crust and a savory flavor that neutral oils don’t. This guide covers the practical side: how much tallow you need, how hot to run it, how to reuse it, and what it costs.
Quick answers
- Is beef tallow good for frying? Yes. It’s stable at frying heat, and most frying happens at 325–375°F, comfortably below tallow’s smoke point of about 400°F.
- What temperature? About 325°F for the first fry of French fries, 375°F for the second, 325–350°F for fried chicken, 350–375°F for fish.
- How much? Roughly 2 pounds of solid tallow per quart of melted fat. A typical 3-quart home fryer takes about 6 pounds.
- Can you reuse it? Yes. Strain it after each use and it lasts several sessions, longest if you mostly fry potatoes.
How much tallow do you need?
Tallow is solid at room temperature, so you buy it by weight and fry with it by volume. As a rule of thumb, about 2 pounds of solid tallow melts down to roughly 1 quart.
| What you’re frying in | Melted fat needed | Solid tallow (approx.) |
|---|---|---|
| Small countertop fryer | 1.5 quarts | about 3 lb |
| Dutch oven, 2–3 inches of fat | 2–3 quarts | about 4–6 lb |
| Standard home deep fryer | 3 quarts | about 6 lb |
| Large home deep fryer | 4 quarts | about 7.5 lb |
| Shallow-frying in a skillet (½ inch) | 2–3 cups | about 1–1.5 lb |
Our 7 lb bucket melts to about 3.5 quarts, enough to fill most home fryers in one go. The 30 oz jar melts to about a quart, which suits shallow frying, a small fryer, or topping up.
Frying temperatures by food
| Food | Temperature | Notes |
|---|---|---|
| French fries, first fry | about 325°F | Cooks the inside until soft but pale, 5–6 minutes |
| French fries, second fry | about 375°F | Crisps and browns, 2–3 minutes |
| Fried chicken (bone-in) | 325–350°F | Fry to an internal temperature of 165°F |
| Chicken tenders and wings | 350–375°F | Smaller pieces can take more heat |
| Fish and tempura | 350–375°F | Fry last; fish flavors the fat |
| Onion rings, vegetables | 350–375°F | Pat vegetables dry first |
Use a thermometer. Adding food drops the temperature, so fry in batches and let it recover between them. If the fat starts to smoke, turn the heat down. For a full comparison of smoke points, see this smoke point chart for tallow and common cooking oils on Cooking With Tallow, our sister site.
How to deep fry with tallow, step by step
- Melt it gently. Spoon the solid tallow into a heavy pot and melt it over low heat. Some countertop fryers warn against solid fat on the heating element; if yours does, melt the tallow in a pot first and pour it in.
- Don’t overfill. Fill a pot no more than halfway, and a fryer no higher than its max line. The fat rises when food goes in.
- Heat to temperature. Bring it up to the temperature in the table above and check it with a thermometer.
- Dry the food. Water makes hot fat spatter. Pat potatoes and vegetables dry, and let battered food drip before it goes in.
- Fry in batches. Crowding the pot drops the temperature and makes food greasy.
- Drain and season right away. Use a rack or paper towels and salt while it’s hot.
Keep a lid nearby, never leave hot fat unattended, and never put water on a grease fire.
How to strain, store and reuse tallow
One of tallow’s big advantages is that you can use it more than once.
- Strain it while it’s warm, not hot. Let it cool until it’s safe to handle but still liquid, then pour it through a fine-mesh strainer lined with cheesecloth or a coffee filter.
- Store it covered. Keep it in a sealed container in the fridge, or in a cool, dark place if you’ll use it again soon. It turns solid as it cools, and that’s normal.
- Keep fish fat separate. Fat used for fish takes on its flavor. Use it for fish again, or fry fish last before you throw the batch out.
- Top it up. Adding some fresh tallow each session helps a batch last longer.
How many times you can reuse it depends on what you fry. Plain potatoes are gentlest. Breaded and battered foods leave crumbs that break the fat down faster. Rather than counting uses, look for these signs that a batch is done:
- It has turned much darker or looks cloudy
- It foams up when food goes in
- It smokes at temperatures it used to handle
- It smells sour, fishy or “off”
To throw it out, let it solidify, scrape it into a bag or container, and put it in the trash. Never pour fat down the drain.
What does frying with tallow cost?
Tallow costs more upfront than vegetable oil, but you reuse it, so the cost per session is what matters. Here’s an example with our 7 lb bucket at its current price of $64.97, about $0.58 per ounce:
- One bucket fills a 3–3.5 quart fryer.
- If you strain it and get five frying sessions out of that fill, the fat costs about $13 per session.
- Mostly fries and a little topping up could stretch it further. Lots of breaded food will shorten it.
For deep frying, buying by the bucket makes a real difference. Per ounce, the bucket is about 40% cheaper than the 30 oz jar ($0.58 vs. $0.98). See our guide to buying beef tallow in bulk for more on sizing.
Beef tallow French fries
The classic reason to fry in tallow. Cut russet potatoes into ¼–⅜ inch sticks, soak them in cold water for 30 minutes, and dry them very well. Fry at 325°F until soft but pale (5–6 minutes), drain, and let them rest for at least 10 minutes. Just before serving, fry them again at 375°F until deep golden (2–3 minutes). Salt them right away.
About LeRoy’s beef tallow
LeRoy’s is 100% beef tallow, one ingredient, with no additives, preservatives or seed oils, rendered in the USA. It’s conventional beef tallow, not grass-fed. Every order ships free and comes with a 30-day money-back guarantee. You can buy it in our shop, and see our where to buy page for the other places it’s sold.
Frequently asked questions
Can I mix tallow with vegetable oil for frying?
You can. Fast-food chains used to fry in tallow blends. You’ll get less of the tallow flavor, and the mix lasts about as long as its weakest fat.
Does food fried in tallow taste like beef?
Not strongly. Good tallow adds a mild, savory richness, most noticeable on potatoes.
Can I use tallow in an air fryer?
Yes, as a coating. Toss food in a spoonful of melted tallow before air frying. Don’t pour liquid fat into the basket.
Why is my tallow solid in the bucket?
That’s normal. Tallow is solid at room temperature and melts at roughly 100–115°F, so it turns liquid quickly over low heat.

